Club 80-90 Forums

My van has at some time in the past had an aditional ignition switch fitted to the dash, doing away with the one on the steering colum. There are only 3 wires going to it :- Single big dia Red. single big dia Red/black and a double small black cable, is the standar wiring for the original switch or is it missing summet?
Im wanting to revert back to the original switch , if these wires are the correct ones which terminasls do they attach to on the original switch.
Oh yeah , dont know if its relevant but the van has Lpg so there are a few more wires up at the dash end dont know if this has any relavence to the new switch being put in.
Cheers Daz

Checked the original switch today and only getting continuity between 2 me the terminals when the key is in the start position . Ill be getting Me a new switch tomorrow and take it from there

if it helps anyone else heres where the wires go. easy if youve got a connector block but if just loose wires its a different matter
the terminals are numbered on the back of the plastic housing

30 :- Big Red
50 :- Big Red/ Black
15 :- Twin small Black
x :- yello/black
s:- nothing
p:- grey
might help someone
Daz