Club 80-90 Forums

will they fit T25. I know they are a 5 112 fitting but will they go straight on or do the holes need machining ?

Pretty sure they'll need the centres machined out and possibly the bolt holes too, I cant remember exactly, have you checked the Wiki and the wheels thread on t'Yard?

You'll obviously need longer bolts/studs too. I think the offset is useable, again from memory, so I could, easily be wrong about that Worth converting fronts to studs whilst you're doing it too

WHS...^^^

if they are steels then they fit on no spacers needed.

the bolt holes are a touch tight, once i had fitted and removed mine a few times it was fine , its that little

if its the ally rims then the centre bore is fine, just the lip that holds the center logo in.... i cant remeber what its like on the 15" ally rims.

offsets wise i think the genuine 15" alloys were 6x15 et 37 (not 100% on that)

from what i can remember there are two verions. the ones with the big plastic cap..
these wont fit with the caps.

and the earlier RS style one these are the ones that i think need the lip removing to clear the grease cap on a t3.
(this is the same problem on the 16" granny cosworth rims)