Club 80-90 Forums

Working om my van and ive noticed that the side panel around the rear windows is not fixed in any way to the inner section of the van. Is this normal?
Just wondered if it was worth adding some bracing between the two parts.
Ta

Throw up a pic or 2 Jon.

Will do tomorrow . Just started my night shift:-(

Thats because its a panel van conversion. If it was a factory van it would have the inner and outer joined where the seal would sit. As for bracing, I cant say i have seen anything done before as the glass will add a certain amount of rigidity to the panel.

Just taken a pic

It just looks a large area around the window with no supporton the outer panel

Perfectly normal for a panelvan conversion

ok cheers mate, nowt to worry about then

1664 wrote:Perfectly normal for a panelvan conversion

Do you know where you can get the inner window seal that you've peeled away? Mines the same a converted panel van but I have a large section of the inner seal missing.
Thanks in advance.

Try sealsdirect.co.uk - they do loads of different seals for almost any application.

Thanks for your help, ordered a new inner window seal this morning

1664, dont tell me youve got your dog trained to use the Portapotti

Dazco wrote:1664, dont tell me youve got your dog trained to use the Portapotti

Not my dawg, it's my mate's. To be fair I've never trodden in anything unpleasant round his place so maybe the dog does use the portapotti.....

Dazzler 441 - hello there! I was wondering how you got on with the new rear window inner seal. I have the same problem you had and looking for a seal to do the job - which seal did you go for and how did it work out?

PM him as he might not see this as it's an old thread. Click on the PM tab under his username and avitar