Page 1 of 1
1Y flywheel bolts...how to tighten correctly?
Posted: 31 Dec 2011, 10:07
by Niander
Hi guys ive been told that the bolts on the 1Y 1.9 D tighten to
60nm plus 90 degrees
is this correct ?
i have the new bolts to fit
and is the procedure to gradually tighten to 60nm
on the bolts and then turn every bolt gradually though 90 degrees
I want to "make sure" as i dont want to strip out the crank!!!
cheers
Re: 1Y flywheel bolts...how to tighten correctly?
Posted: 01 Jan 2012, 09:43
by Niander
O well i will assume this to be correct then
as i am so inundated with replies!...it must be!
Re: 1Y flywheel bolts...how to tighten correctly?
Posted: 01 Jan 2012, 23:57
by futbus
Normally there 60nM plus 90.
Re: 1Y flywheel bolts...how to tighten correctly?
Posted: 02 Jan 2012, 08:48
by Niander
OMG dont tell me there is another 90!
Anyone has a manual please?
ive now been told 3 different torques on this crucial part!???
Re: 1Y flywheel bolts...how to tighten correctly?
Posted: 02 Jan 2012, 09:06
by syncroandy
I just checked the factory manual for a 95 golf fitted with 1Y and manual trans (normal flywheel). The flywheel bolts are 60Nm + 90 degrees, and renewed. Fresh bolts also come with an locking compound already applied. It would do no harm to tighten opposing bolts in a couple of steps though I doubt this is as critical as it is for a cylinder head for example.
Re: 1Y flywheel bolts...how to tighten correctly?
Posted: 02 Jan 2012, 19:28
by Niander
Hey thanks alot!
ill go with this...