Page 1 of 1

Plastic Centre Console Heater Vent Cover thingy

Posted: 30 Dec 2011, 21:50
by Seamus
I have a conundrum...

I have picked up one of those snazzy centre floor sections that sit between the front seats and vent some warm air into the rear of the van.

However, my black plastic cowling thats clips onto the dash just behind the gear lever doesnt seem to fit back on when the floor section is in place, so... my question is this, is there a different shaped plastic bit to fit these rear heating floor thingies :?:

If so a post will be entered into the 'wanted' section in a jiffy! :P

Re: Plastic Centre Console Heater Vent Cover thingy

Posted: 31 Dec 2011, 01:11
by texasuk
In a word - yes.

Re: Plastic Centre Console Heater Vent Cover thingy

Posted: 31 Dec 2011, 21:15
by Seamus
Roger that - thanks mate... Im off to the wanted section then :roll:

Re: Plastic Centre Console Heater Vent Cover thingy

Posted: 03 Jan 2012, 18:25
by kevtherev
Ask here first before buying things.
We could have told you that this upgrade needs the cover :ok

Re: Plastic Centre Console Heater Vent Cover thingy

Posted: 03 Jan 2012, 21:52
by Plasticman
Aye and I been eyeing up your tunnel and bits. :mrgreen:
mm