Club 80-90 Forums

I'm currently looking to buy some Audi A6 wheels 7J x 16" 5x112PCD ET 35. Other than having to machine the centre bore for the front, do I need different wheel studs/nuts/bolts or spacers?

I'll also be lowering the van by 60mm (AVO kit), will there be any fouling?

Any advice appreciated.

I have fitted A6 SE 16" wheels to my wagon with a 60 mm drop, I needed front spacers and long bolts (converted over to the longer studs/nuts supplied by Brickwerks)
http://www.brickwerks.co.uk/
as you know machine centres to approx 62 mm (ish).
The problem (fun) I found was in tyre clearance between inner tyre wall and upper suspension arm (spring/shock top mount), got over this by spacing, however wheels a stick out a way wider on front, so in hindsight I would have fitted 205/50 VR16 tyres to front , I have 225/50 16" fitted all round at present. The rears will need conversion studs also (Brickwerks) and spacers.

Just going on my experiences, sure others will have different method.
Have fun..
G.

Thanks for the advice.