Club 80-90 Forums

I've got a set of 4 T4 wheels cluttering my garage. Got them thinking they'd fit my T3 syncro but since found out that I'd need to machine out the centre hole and use spacers to compensate the offset.

Now trying to work out if it's worth it.

What would rough cost be?

They are 6Jx15, ET55, part no 7D0601027A

I've asked myself this question once or twice: is it really necessary to machine out the centre hole of the wheel if you have 25mm spacers (to get to ET30) between it and the hub?

Ah good point
Now realised that I'd have to change studs each time I swap wheels