Club 80-90 Forums

needing to replace bleed nipples on rear cylinder on 16" the part number is listed as 211611477a for 14" and numerous others ie beetles any ideas peeps if they are fot for front & rear ona 16"....cheers all

211 611 477 A, it's the same.

cheers simon have you them on the shelf?....

na.
If they are siezed I just put new cylinders on, labour spent on removing them is usually more than the cost of a cylinder.
I never un do them either, i just hit them with a hammer to break them off to save time, so no second hand ones either.
It's M6 so nothing fancy, most motorfactors will have them in one of those slide top selection packs they usually have.

I just replaced mine, as you know xriss I fitted new cylinders (came with bleeders attached) only cost about £28 for both of them. I also found on removing old cylinders, even though they looked good the movement on the piston was very notchy, so it could be worth checking that as well?

lloydy wrote:I just replaced mine, as you know xriss I fitted new cylinders (came with bleeders attached) only cost about £28 for both of them. I also found on removing old cylinders, even though they looked good the movement on the piston was very notchy, so it could be worth checking that as well?

Go on xriss .... get new ones. Just think how old the ones you are pfaffing about with are ....

nowt like spending other folks money
m

metalmick8y wrote:nowt like spending other folks money
m

Better than spending mine

Your turn will come
m