Wiring Diagram Please
Posted: 05 Aug 2011, 12:07
Has anyone got a wiring diagram showing the two 'Earth Crowns' behind the fuse board, and in particular where the earth wires from the crowns connect up to.
I have a problem with my near side headlight being very dim. Through a process of elimination I have found the earth connection on the crown for the lights but there are two wires on this spade, one appears to be connected the other end OK. The second very short wire (approx 12cm's long) on this spade is not connected the other end. It has been stripped back, suggesting it was connected to a spade or something, but I cannot find anything that is missing a wire.
Being such a short wire the connection has got to be very close to the crown. Just above the crowns there is what I would call a Junction with two relays. I can't see where a wire would go but it's in the right area. The other possibility is in the back of the fuse board, but again I can't see where.
In attempting to cure the problem I have already tried to make sure of good earth connections and replaced some female spades, but the lights remain dim on the nearside. (offside are working OK)
Any help/suggestions/diagrams much appreciated.
Cyprus Dave
PS. Hope it's OK to send this second Post on problem
I have a problem with my near side headlight being very dim. Through a process of elimination I have found the earth connection on the crown for the lights but there are two wires on this spade, one appears to be connected the other end OK. The second very short wire (approx 12cm's long) on this spade is not connected the other end. It has been stripped back, suggesting it was connected to a spade or something, but I cannot find anything that is missing a wire.
Being such a short wire the connection has got to be very close to the crown. Just above the crowns there is what I would call a Junction with two relays. I can't see where a wire would go but it's in the right area. The other possibility is in the back of the fuse board, but again I can't see where.
In attempting to cure the problem I have already tried to make sure of good earth connections and replaced some female spades, but the lights remain dim on the nearside. (offside are working OK)
Any help/suggestions/diagrams much appreciated.
Cyprus Dave
PS. Hope it's OK to send this second Post on problem