Page 1 of 1
How to fit a rock and roll
Posted: 04 Aug 2011, 10:34
by el_kel1
Have a siney new RR bed constructed and ready to it to my van? any tips? or how to's?
Re: How to fit a rock and roll
Posted: 04 Aug 2011, 11:09
by jamesc76
what make is it ???
Re: How to fit a rock and roll
Posted: 04 Aug 2011, 12:08
by el_kel1
volkswares, went together a deam, but now making it become part of the van hahaha
Re: How to fit a rock and roll
Posted: 04 Aug 2011, 14:27
by CovKid
If two big burly bikers can't tear it out with their bare hands - its fixed right. Thats not a bad guide. On my DIY one (in WIKI) I used spreader plates (flat bar fashioned into giant washers) anywhere I put a bolt through any bodywork. Self tapping screws ok for holding furniture together but not adequate for securing a seat. That should point you in the right direction.