Page 1 of 1
t25 gear box
Posted: 15 Jul 2011, 06:56
by slick
Hay can any one help please i have the problems with geting my t25 in to gear i thouth it was the gear selecters but was told it is the rod going in to the gear box.
Can ths be fix or is it and new gear box.
Re: t25 gear box
Posted: 15 Jul 2011, 08:17
by Ian Hulley
Welcome to the forum
With the engine switched off remove the 2 8mm nuts and bolts that hold the linkage to the gearbox (making sure you note where the plate fits to put it back on) and see if you can get the gears by hand on the selector lever. The linkage may just need adjusting, the 2 bushes along the link rod may be worn to excess or the box may be buggered ... in which case you'll be needing the services of Aidan Talbot.
It's also possible the clutch isn't disengaging because the spigot bearing has failed and it's spinning the gearbox input shaft.
Ian
Re: t25 gear box
Posted: 15 Jul 2011, 17:43
by slick
hay thanks i no there is play in the front and mild one as well so not really sur on it s new to the t25s as will