Club 80-90 Forums

Hi peops

I am after a little advice, have found some merc CLK 16"wheels. Offset is 37 and they are 7j.
The van has been lowered 50-60mm and is currently sitting on EMPI 5's 15"(i know, i know the only thing i did n't research before buying the van was the flamin wheels)

Have done some resarch some places say the merc alloys will fit but others say very tight even with the spacers.

Any ideas and i do apolologize if this has been covered

Cheers Phil

They might fit but seen a few T25s with dents in wheel arches when they've gone on full lock.

Mine are et42 7.5J and I needed 15mm spacers on the front to stop the wheel rubbing the suspension on full lock. 20mm spacers on the rear

There is no definitive guide but I'd say you are limited to 10mm spacers on the front which may work. You won't know until you fit them