Page 1 of 1
fitting an alloy bullbar
Posted: 21 Apr 2011, 20:06
by scottbott
just a query,is the 'beam' behind the front bumper deeper on big bumper vans than earlier vans,as I reckon I need bolts about 12 inches long to go through that beam and through the chassis rail behind the bumper,if that makes sense
Re: fitting an alloy bullbar
Posted: 21 Apr 2011, 20:10
by lloydy
Weren't they attached to the bullbar already? Hanging off where you would put spots
Re: fitting an alloy bullbar
Posted: 21 Apr 2011, 20:23
by scottbott
yes they were but they are not long enough,stuck my hands up where I can and cant feel them,tried a long thin bar and it pokes through a hole,will have to put a plate or something over it then a large washer