Club 80-90 Forums

hi al,
could any one please tell me how to remove my ols hockey stick shaped window rubbers ? i dont want to damage them as i want to put the inside ones to the outside as i think they are interchangable. do they just pull out or do i need to release them some how? thanks for any help.

Open window and pull them up carefully. They sit in little clips on the inside of the door which can be delicate after years of rainwater.

Once you get one off you will see what I mean.

Do you really want to lean your arms on the grubby/split seals when you put the outside ones on the inside?

I did this and it actually reduced the amount of water getting into the door when I wash the bus. Which was the plan as I'm not willing to pay the daft amount required for new ones!

I removed mine as above but found it easier to pull out the section of seal at the rear of the door first to give better clearance when removing them.

thanks for that guys, i will give it a go over the week end.