Club 80-90 Forums

Hi there,

I have a t3/25 panel with a ej22 and i desperately need a new exhaust. It has a total piece of crap on it right now, done by whoever did the conversion! So i was wondering if i could fit a normal scooby manifold on it and simply follow with a 180 pipe out to a backbox? but im not sure if it will fit, clear everything, i dont mind a bit of chopping and rewelding but i dont really want to make a system from scratch!.

Has anyone done this?, im not sure if this would fit a ej22 but i bet its not far off.

http://www.just-subaru.com/my03-05-revo ... 054-0.html

oh and hello, i didnt realise this was my first post! being a member of the three top t3 forums!!!
, been a long time lurker here.

Welcome

ok, i guess i will be the first to try!!!

Your main issue will be ground clearance, I used the original headers on my ej25 conversion but its a caravelle minibus so high up but now I'm lowering it I have to rethink the exhaust.

i was thinking of chopping and rewelding like this. but i guess it depends on where it clears the bottome pulley, might have to extend it to the rear.

which engine mount/cradle do you have? any idea`s who did your conversion? any pics of your exhisting zorst may give me a clue ,, just completed a EJ25

Yeah, going out and looking at it.....looks like its gonna be real close to the mount bar.

I bought it off a guy who had it converted by tsr/amr. Its not the best i dont think. Im just going through it and slowly sorting out all the probs. Really close to ripping it all out and putting in a turbo motor!!!.