Club 80-90 Forums

I've just got the input shafts changed as i'm swopping to diesel. my question is do i need to change the release bearing shaft or can i just change the arm for the hydrolic clutch as the donor box was a manual clutch, also the bracket for the clutch cylinder will not fit now due to the starter position on the diesel set up is there a different bracket.

Thanks Tony

diesel slave bracket is different to petrol one, yes you can just swap the lever arm off the end of the shaft if you can get it off

are you putting the whole early diesel / 1.6 petrol box in?

if so i think 50mph is flat out!

no he's using the petrol abd box, just needs to swap over the bellhousing and input shaft and covert it back to hydraulic clutch

Thanks Aidan do you have the bracket and the arm knocking around as i have got the arm of the diesel bell housing but the petrol one is stuck but broken anyway.

Thanks Tony

yeah all of that is on the shelf

Ok Aidan if you could pm me a price for them and a BH gasket n if you dont mind me bobbing over for them but it wont be till later this week as i'm on nights.

Thanks again Tony