Club 80-90 Forums

Hi All,
I'm going to get the rear wheel bearings replaced.
At present they have play when rocked vertically but not horizontally.
They've been like this for a couple of years but at my last MOT the man said "High level of Play".

As I have to remove the rear hub to fit longer studs this may be the best time to replace the bearings.

My question is - Which Loctite Bearing Fit fluid - 641, 648 or 660 do I need to use?

If the bearings are still a press fit then no need for any retainer, if the housing is worn then use 660.

hi titus,

might be able to get some for you from work if you need some. just let us know
will it be okay to post through deutschpost?

bigherb wrote:If the bearings are still a press fit then no need for any retainer, if the housing is worn then use 660.

Cheers Bigherb.
According to the Wiki there is a chance that the carrier is worn and has a bit of play.

660 it is then.

melmelody wrote:hi titus,

might be able to get some for you from work if you need some. just let us know
will it be okay to post through deutschpost?

Hi Mel,
You have PM.
Titus