Page 1 of 1
base settings for32-34 PDSIT
Posted: 24 Feb 2011, 22:58
by dugcati
Anyone have a base setting for the mixture/idle screws for 32-34 PDSIT as found on CU engines - I have a pair that have been totally stripped and rebuilt and wondered of there is a 2 1/2 screws out rough guide for them?..
ta
Doug
Re: base settings for32-34 PDSIT
Posted: 24 Feb 2011, 23:22
by steve8090
2 1/2 is not enough, try 3 1/2 as a base and you will not be far out, and the all important throttle base gap of 0.1mm then balanced to a throughput of 8.5 cu/in measured at tickover on a carb balancer
Re: base settings for32-34 PDSIT
Posted: 24 Feb 2011, 23:30
by dugcati
Cheers Steve - your wisdom is allways welcomed
E D I T - I've added this into the wiki 1/5/2011