Page 1 of 1
16" cv joint - bolt spline drive size
Posted: 23 Jan 2011, 21:49
by Yozza
I'm just taking the rear suspension and drive apart and got stuck at the first hurdle! My spline tool was too small (even though it fits the front inner cvs and the ones on my 2wd). Do the 16" rears have bigger bolts and as a result require a bigger spline drive tool? If so does anyone know the specific size so I can track one down.
Cheerz
Re: 16" cv joint - bolt spline drive size
Posted: 23 Jan 2011, 22:27
by jed the spread
Yeh they are bigger than 14" ones. I noticed this while working on Lloydys van.
jed
Re: 16" cv joint - bolt spline drive size
Posted: 23 Jan 2011, 22:43
by Aidan
m10 multispline
Re: 16" cv joint - bolt spline drive size
Posted: 24 Jan 2011, 09:41
by John Potter
I needed an 8mm 12 point on the rear inner cv bolts, well those that didnt need a cold chisel and a 2lb lump hammer...
Re: 16" cv joint - bolt spline drive size
Posted: 24 Jan 2011, 11:20
by Aidan
irwins
http://www.machinemart.co.uk/shop/produ ... t-grip-set
with the second set as well you have everything from 8mm to 19mm inc imperial
one of the best tool buys for working on older vehicles
Re: 16" cv joint - bolt spline drive size
Posted: 24 Jan 2011, 19:36
by Yozza
Thanks fellas, now I know what to be looking for.
Aidan, thanks for the link, not seen those before. My philosophy is, if it aint budgin threaten it with the angle grinder, however, I may stick those bolt grips on the birthday list (I must be going soft in my old age )