Club 80-90 Forums

Just assembling the wishbones and noticed that I can't turn the long bolt all the way round. It seems to jam half way round (both ways)? I'm sure when I stripped my 2wd the bolts would turn all the way round giving the full cam motion required for the camber adjustment.

Is there something amiss or is the syncro set up different to 2wd? I did notice a bit of rust inside the tube that the bolts sits in...?

Anyone had bent bolts or had similar symptoms?

Cheerz

The bolt that turns the eccentric washer that adjusts the camber only moves about a 1/4 of a turn. Make sure that both washers are orientated the same way, which iirc is when the bolt hole is at the top.

Here is alittle video showing the full movement, looks less than a 1/4.

http://s199.photobucket.com/albums/aa28 ... stment.mp4

Thanks Simon,
The vid was a bonus too
Yozza