Club 80-90 Forums

Hi
I have a new bush ready to go in with a replacement starter motor, but should it be a tight fit on the shaft of the starter or have I got the wrong one, it is quite a loose fit
Any ideas?

Cheers

Mike
1491
2.0l A/C

it goes into the hole that the starter shaft goes into, make sure you remove the one in there before trying to fit the new one.
SEE

http://www.club80-90.co.uk/wiki/index.p ... sh_removal

AND

http://www.club80-90.co.uk/wiki/index.p ... rter_motor

soak bush overnight in engine oil before fitting--its pourous--

i have the new bush and have tried it for size over the starter motor shaft and it isn't a snug fit, seems fairly loose is this correct. Or is it meant to be fairly loose to allow for movement?

Mike