Page 1 of 1
rear corners inside engine bay
Posted: 21 Dec 2010, 14:23
by pugwash
Hi
82, 2L a/c , anyone know the measurements of the so called battery type trays( T2 areas), need to fabricate new ones, any help b4 lying on a snow covered floor would be welcome
Re: rear corners inside engine bay
Posted: 21 Dec 2010, 16:09
by kevtherev
do you mean the plates below the outer air ducts?
Re: rear corners inside engine bay
Posted: 21 Dec 2010, 16:24
by pugwash
Thats correct Kev.
Re: rear corners inside engine bay
Posted: 23 Dec 2010, 19:01
by Plasticman
make a template out of cardboard
mike
Re: rear corners inside engine bay
Posted: 24 Dec 2010, 10:20
by pugwash
metalmick8y wrote:make a template out of cardboard
mike
Yes i know that but the van is snow and ice bound at the moment, and I was hoping to escape the xmas madness for a few hours in the shed making them up ready, and was hoping this fat, old ,athritic wrinkly wouldnt have to suffer the cold/wet conditions, never mind a few beers and I"ll go and dig my way to it
Re: rear corners inside engine bay
Posted: 24 Dec 2010, 11:28
by dugcati
pugwash wrote: fat, old ,athritic wrinkly wouldnt have to suffer the cold/wet conditions, never mind a few beers and I"ll go and dig my way to it
stop talking about the big man in the red suit like that!