Page 1 of 1
Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 01:26
by Iceworx
Morning All,
Just picked up an Eber D2, and i've a few questions if someone could help me with it.
its an Ex BT unit, and I have a timer control panel with it but seems to be an awful lot of wiring.
however not having had one of these before i dont know if I am missing any components etc..
Also I'd like to know where people have fitted them, and if you've got any picyures, that would be fantastic.
I've taken a few pics - below.
Also ive had a look for a wiring diagram for it too, but im drawing a blank. Had a look in the download section of the site, but there are a few dead links.
Anything i've missed thats relevant to my questions?
Look forward to geting some answers on this and hopefully getting it installed so I can use the bus over winter
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 07:41
by windysurfer
Few pictures of mine on this thead.
https://club8090.co.uk/forum/viewtopic.p ... er#p315656
Mine was also ex BT but only had a simple rheostat controller.
Best advice I can give you is to keep the 12v supply as short as possible, using the correct rated cable.
I also replace to old bullet type fuse holder with a newer spade type and remove all other connection along the 12v supply
as most starting problem are due to low voltage.
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 08:29
by Iceworx
Ahhhh Cool! Thanks. Looks good.
Looks like one of the heaters is missing an ecu
also doesn't look like, i've got the pumps for either heater either. Nor the exhaust silencers.
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 08:40
by windysurfer
I think I spent around £100 on top of the D2 on ducts, outlets,inlet,exhaust etc
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 08:57
by Iceworx
Ouch! ECU is £288!
and Exhaust £30 ish
and fuel pump is £155
Ducting outlets etc im not too worried about
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 10:51
by Oldiebut goodie
Ecu £50 - £90 on german ebay.
I've never paid more than £25 for a good 2nd hand fuel pump ex ebay.
Silencers not usually needed.
pm me your email if you need manuals.
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 12:26
by Gandalf
Iceworx wrote:Ouch! ECU is £288!
and Exhaust £30 ish
and fuel pump is £155
Ducting outlets etc im not too worried about
I've an ECU from the D2L - not sure if it will fit the D2 tho? any ideas Oldie but goodie?
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 13:06
by Iceworx
Oldiebut goodie wrote:Ecu £50 - £90 on german ebay.
I've never paid more than £25 for a good 2nd hand fuel pump ex ebay.
Silencers not usually needed.
pm me your email if you need manuals.
Thats very kind My email is chris "at" realgraffix.co.uk
and i'd better brush up on my german
Thanks, Chris
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 13:07
by Iceworx
Gandalf wrote:Iceworx wrote:Ouch! ECU is £288!
and Exhaust £30 ish
and fuel pump is £155
Ducting outlets etc im not too worried about
I've an ECU from the D2L - not sure if it will fit the D2 tho? any ideas Oldie but goodie?
If you could get the part number off the side, i'll have a look into it..
Starting to feel like i've had my pants pulled down with this one..
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 13:51
by Oldiebut goodie
D2 & D2l are two completely different beasties.
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 14:20
by Gandalf
Oldiebut goodie wrote:D2 & D2l are two completely different beasties.
Thought as much but thought I'd best check with the Eber fountain of knowledge!
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 14:44
by Oldiebut goodie
You are looking for .....
Eberspächer Steuergerät Airtronic .... there is only a 24v one there at the moment. cut and paste and you will keep your umlauts on the 'a's. Check that the seller takes paypal and sends to UK. Bidders there tend to bid properly - ie leave it to the last few seconds!
Re: Got an Eber D2 - few questions..
Posted: 09 Nov 2010, 15:41
by Gandalf
I think Jed has just fitted one of these to replace his Propex - he maybe able to get an ECU - might be worth a PM to him?
Re: Got an Eber D2 - few questions..
Posted: 10 Nov 2010, 09:57
by Iceworx
Thanks buddy, I've sent him a quick PM