Page 1 of 1

Propex question pt2

Posted: 07 Nov 2010, 20:31
by toyclean
A little while ago I asked a few questions about the propex heater units as mine wasn't working. I decided to leave it until the new year when hopefully I'll have some pennies to get someone to take a look.

But, today while out I think I knocked the 'on' switch before I left the van while out. Came back a few hours later and could hear a whirring noise, low and behold it was the heater fan. I turned on the gas and got heat out of the darn thing. It smelt a pretty dusty and was noisier than I expected.

So, given this minor 'miracle' has anyone got any tips? I've already given thanks to the god of old veedubs!

Cheers.
MT

Re: Propex question pt2

Posted: 07 Nov 2010, 21:34
by donnieg
Yes now that it is working you should run it at least once every month or two for a short time this will stop the bearings from bedding in.

Re: Propex question pt2

Posted: 08 Nov 2010, 10:17
by Aidan
you probably had a flat leisure battery when you last tried it

Re: Propex question pt2

Posted: 09 Nov 2010, 23:57
by toyclean
Ah, no. The leisure batt was fully charged. This was truly a miracle!

Just crossing my fingers that it will work next time...

MT