Club 80-90 Forums

What's the easiest way to remove the glass and seal intact, I want to smash them or cut the seal but the seals are good and windows well can be sold on.

Any advice would be most appreciated cheers all

which wynder

Rear side windows seal will lift, is it case of leverage and pressure

That depends on if they are original windows or a panel van jobby.....Original ones...From the inside starting at the top, use a screw driver to push the seal the other side of the panel/steelwork, mind you don't slip till you can feel the window becoming loose then just wiggle/lift out.. Panel vans ones...remove the bead on the outside of the seal then do the same as above...thats how we take them out anyways
IAN

I used the tyre levers for my mountain bike, less chance of causing damage than a screwdriver.

Westy original windows so from the top push seal and wiggle cheers I'll give it another go.

Thanks again for the advice

The front screen is the most awkward. If you need to do it I'll tell you how.

That's it both done double glazing in, thanks for all the input and help especially Ian.

Now just the propex to fit

armyphil wrote:
Now just the propex to fit

A nice picture 'how to' would be great

Cruz wrote:

armyphil wrote:
Now just the propex to fit

A nice picture 'how to' would be great

yup..second that..(and third it ,if it helps)

Hopefully it's one of the big old X1 heaters and not one of the girly newer ones

Wil do tommorow when I start had a few now so no power tools tonight.

It's the new Gorky one I have the heat source 2000 or something like that.

If you like when in done shall I post on the instructions to you? I imagine their relatively similar

Great. Especially the electrical and copper wiring side

Double glazing? Can I ask how that works then? Can you buy replacment windows from somewhere?

Pictures are always welcome for jobs like this, would be great to see what you did and how.

Weldore,
What pictures do you require?
I put my new girlie size propex under the RnR seat, it's a no brainer of an installation.
Just two large holes for the propex intake and exhaust, a hole for the hot air feed duct and wiring.

If you want pictures of it just shout.