Club 80-90 Forums

I've noticed a bit of oil leaking from the base of the tube that the dipstick fits into, the tube itself can be rotated, but doesnt seem to pull out.
Hows it fixed in place as the manuals dont show it, I'm a bit reluctant to just pull hard incase it breaks.
I've searched the site and theres lots on dipdticks needing adjusting for different reasons, but cant find anything on fixing the tube in place.
Thanks
Dan

1.9 dg engine

as afr as i can remember it pushes in with and o ring on it to seal it

My T25 has a 19d mk1 golf lump in it and its a 13mm bolt on the top end of the dipstick tube. and at the block its a washer and o ring (brickwerks £2.85p). and beleve me you need the washer kit or it will not stop leaking.

Thanks for the info, will have a look over the weekend
Dan

On a DG/DJ the dipstick tube has an O-ring at the base as Dug says, once correctly seated the tube should be held firmly in place against the alternator bracket with a clip.

Ian

Ah, so me clips missing as it wobbles about.
Will have a closer look and see if I can "manufacture" something
Cheers