Club 80-90 Forums

hi i am compleatly revamping my van and have had a few threads on here .. at the muinet i am at the stage of fitting a new headlining but am not sure how to do it , i was thinking of just carpeting it for the cost wise but am not really sure on how to do it , dose any one have any advise on how to do it or on whatother material to do it with ?:P

cheers nicko

Hi

just done the cab headlining using perforated vinyl and the template in the wiki,
Its come out not to bad at all it needs a little streching to take a couple of the creases out but very nearly a factory look.
I'll post some pics when I get a chance.

Cheers
Si

hi , cheers yeah i think i will do that , how wide dose it need to be though as it dosnt say on the template ...also i am going to put a pop top on my van , how do i do that with my new headlineing , the hole ect ...

cheers nicko

I also need to sort out my head lining, so any tips or pictures would be appreciated.... Cheers,

Hi,

the width dosent matter (oooeeerrr) as you will be trimming it to fit, I made mine the width of the material 1.4 m, I used this

http://cgi.ebay.co.uk/PERFORATED-Vinyl- ... 53e3978f1f

it sews up quite nicly


mine is only for the cab you can see where the rods make a nice crease and that I have one or two other creases to sort out, but its not as hard as it seems at first.

Good luck

Si

Aberdeenbus wrote:Hi,

the width dosent matter (oooeeerrr) as you will be trimming it to fit, I made mine the width of the material 1.4 m, I used this

http://cgi.ebay.co.uk/PERFORATED-Vinyl- ... 53e3978f1f

it sews up quite nicly

head lining.jpg

mine is only for the cab you can see where the rods make a nice crease and that I have one or two other creases to sort out, but its not as hard as it seems at first.

Good luck

Si

Looks top notch...