Club 80-90 Forums

Hello,

the worktop in my van where the sink and gas stove are is pretty knackered, and I wanted to try and get hold of a new piece and cut it to fit, but the laminate stuff you can buy for kitchens is too thick and I don't need 3m of it! Does anyone know where I might be able to find sheets of slightly thinner laminate that they used to use for these vans? I'm being lazy and the bit cut beyond the sink is fine so would like to just replace the bit that's gone. If this isn't possible, then any suggestions of where to get good (hopefully cheap) stuff to replace the whole lot would be much appreciated!

Thanks a lot

Ewen

Post a pic of the laminate then we may be able to give you an idea on where to get some.

Mark

Is the wood knackered or just the work surface?

I recovered the worktop with this hardwearing vinyl.

Auction ended today but I'm sure if you contact him he'll have some

http://cgi.ebay.co.uk/D-C-FIX-PORRINHO- ... e1ff2a0528" onclick="window.open(this.href);return false;

timbertechs can get you lamiated ply , 12mm which is the right size for the leisuredrive tops, however, i doubt the colour matching will happen, leisuredrive had there made for them, and its well out of production.....

I used the same stuff as cruz and its pretty good if the wood is OK.
The DC-Fix is on the right in the pic I got the grey edging of flea bay aswell

Hello again,

thanks a lot for all the really helpful replies. I'm attaching a couple of dodgy photos, but I think it might be a bit late now! Perhaps if I can find 12mm worktop it'd be worth doing it all again properly...

Ewen

good work on the laminate fix! Unfortunately there is a bad break in the wood (which isn't shown), which supports the gas cooker and the side block next to the fridge... will check timbertechs...

thanks a lot!

Ewen

Hello,

sorry to be a pain but is there a link for the laminated ply for timbertechs you could send me?

Thanks a lot

Ewen

http://www.timbertechnicians.co.uk/index2.html" onclick="window.open(this.href);return false;

thanks a lot - will look into it...