Club 80-90 Forums

Excuse me if this has been asked before, I have done a search but no luck.
I have just got my first T25 (1993 2.1 holdsworth poptop).the drivers seat Is little tired and I have been offered a pair of Subaru WRX front seats in a plain grey for beer money(quiet night beer money). Thing is will they fit? And how hard can they be?
Anyone got any tips or experience they can pass on

Regards Roland

I fitted subaru legacy seats in mine, do you have access to steel and a mig welder ????

I have been told( by my better half) that the Wrx seats arn't quite in keeping with the van. I do however think the Legacy seats would look good so might hunt a pair of them.
Yep I have access to a friend with a welder etc.

Roland wrote:I have just got my first T25 (1993 2.1 holdsworth poptop)

That's a very late van you've got there - K plate?...would be a shame to spoil it...imho

Yep , K plate . Registered march 93.

The drivers seat has gone flat at the sides and the covers look like they have come from a seventies caravan.
Went to Wales and back at the weekend and they wern't to uncomfy tho. Otherhalf did say that the edge of the dash tidy could do with a bit of padding for when her feet are up there .

I was thinking same.thing too. Only k plates i know of are LLE,s and south africans. Would.be nice to see a pic . Do u have any?

i've got a couple of pics on the Iphone but not sure how to post them up on here, i will have to have a look.

I picked it up from Brighton and am its 3rd owner, the guy said it was the last one that Holdsworth converted , not sure if that true or not tho.

They had the last 30 odd vans from volkwagen after the t4 had come out and converted um!