Page 1 of 1
Running temp.
Posted: 15 May 2006, 10:55
by Horney
My 1.9 DG used to run with the needle sat opretty much dead centre.
The last couple of days it's not climbing past the top of the cold block of white.
This has me a little worried that everything may not be right somewhere, does anyone know what could cause this? THe weather has actually been warmer recently so it's not down to the outside temperature.
Where does the dash gauge pick up it's reading? One of my thoughts was that the water pump maybe dieing and not pumping the coolant round effieciently or that I have an air lock. Any ideas?
Cheers,
Nick
Posted: 15 May 2006, 12:56
by tonytech
Dash guage picks up from temp sender in thermostat housing.
Thermostat failed open?
T
Posted: 15 May 2006, 13:05
by Horney
OK i'll have a look at that.
I would have thought tho even with the thermostat stuck open it would get above cold on my drive to work which is a combination of dual carriage way (70mph cruise) and stop start traffic.
Nick
Posted: 15 May 2006, 15:09
by TSM
I would imagine the best way to check if its the thermostat would be to leave it ticking over on the drive. That way the radiator won't cool the fluid down, if the temperature reaches normal level its your thermostat.
Posted: 15 May 2006, 15:18
by Mocki
if its early water sys it is more than likely the sender, just ( finally) got round to replacing mine last week, little brass jobber, went open circuit last year!
Posted: 15 May 2006, 15:26
by Horney
It still moves, just not very far. I'll try leaving it on tick over and checking the rad and see what happens and report back tomorrow!
Nick
Posted: 15 May 2006, 17:23
by Horney
Ok took it for a good run on the way back from work as well as a nice long traffic queue. Turned on the blowers and lots of nice hot air but the temp gauge still only read half way through the cold white block.
From this I assume that the thermostat is working as the heaters only started blowing hot air after about 5 mins of driving.
Sound like the sender unit to you guys?
Nick
try...
Posted: 15 May 2006, 21:09
by billy739
remove the wire from the sender on the engine,earth it out,watch the temp gauge when you turn ignition on,should climb to top pretty sharpish,turn ign off,this will test the wiring circuit!
Posted: 16 May 2006, 05:46
by ROBS T25
mine sits pretty much the same place has done since i had it just on the line been flushed out twice and seems fine and dandy my moto matey dont fix it if it aint broke at least it aint overheating
i thought something wrong with mine to but i had my van tickling over for 45 mins still no change so i not worried at all!!