Club 80-90 Forums

Had the instrument pod out over the weekend to find out why somethings not working.

Found that the wiring to the rev counter seems to be incomplete.

From the printed circuit board there is a extension piece with three square terminals which looks like it should plug into the back of the rev counter, as there is a square hole with what looks like four pin holes, so am I missing some sort of plug from behind there?

Thanks

pins go in the holes, little plastic tang on the circuit board to tug it out.

Not these holes unfortunately.

The holes in the back of the rev counter are in what looks to be a square hole for a plug, with four round pin sized holes.

The terminals on the end of the circuit are squarish and about 2mm square and there is three of them on the end of a bit of extended circuit.

Thanks

Would like to get this fixed if possible, so here is a picture, of what it should be like, I have the small bit of circuit which goes to the back of the rev counter and from the pic you can just 3 see the pins (white dots) on the circuit, I just need what they are supposed to plug into.