Hot Cold Heater cable adjustment
Posted: 04 Jul 2010, 16:55
My hot/cold heater cable is not connected to the lever on the dash. The cable looks twisted so i think i will need to replace it. Has anyone done this before? I followed the cable to the valve above the spare wheel. It looks a little tricky to access the value, remove the old cable, fit an new one and then re-adjust it. Any suggestions welcome.
-the reason for doing this is that my feet are getting constantly blasted by very hot air which i cant stop. I am hoping that the hot/cold level once fixed will solve the problem. I have burnt out my heater blower (there was smoke) trying to keep my feet cool (also need to replace that too). I have just taken the facias off the dash where the vents to the floor ducts are so the hot air is not now blowing directly onto my feet which is a little better.
Only had my van 3 weeks so bit of a novice - although managed to fit a new speedo cable already!!!
Thanks
-the reason for doing this is that my feet are getting constantly blasted by very hot air which i cant stop. I am hoping that the hot/cold level once fixed will solve the problem. I have burnt out my heater blower (there was smoke) trying to keep my feet cool (also need to replace that too). I have just taken the facias off the dash where the vents to the floor ducts are so the hot air is not now blowing directly onto my feet which is a little better.
Only had my van 3 weeks so bit of a novice - although managed to fit a new speedo cable already!!!
Thanks