Club 80-90 Forums

Yes having been tipped of about a potential MOT failure BY elite who did my engine I took the bull by the horns and removed my fuel tank. The problem was an area of rust to the right of my drivers seat well within the distance permitted in an MOT. Trouble is this is only inches away from the fuel filler and having been involved in a couple of vehicle fires I just haven't got the bottle to weld anywhere near a fuel tank full or empty.
I have to say that I was horified by the tales of plumbing woe in an earlier thread and this was not lesseded when I took mine out. While my exansion and crossover pipes were all in place I do have a split and degraded filler tube rubber. I believe this contributed to the rust. These appear to be unobtainable new so I will manufacture a suitable replacement set up. Although my tank and plumbing was otherwise sound I have cleaned and hammerited it and intend to replace and Jubilee clip all pipes. I realise it will be tricky to get all the pipes back on as I refit the tank but intend to fit the expansion tank and hopefully the crossover pipes to the tank and theead the free ends as it goes up. Fingers crossed. I anyone is interested that large circular plastc bezel gismo around the filler cap rotates by a few degrees to remove just like a light bulb. I warmed mine witha hot air gun to make id easier.
All the work is done now except for replacing the tank. Maybe tomorrow now...
Cheers
wolfie

use proper hose clamps do not think jubilee clamps are the best thing to use,used stainless on mine

If you mean then rubber conector that goes from the fuel filler cap to the tube that goes down into the tank you can still buy them new. They are listed on Brickwerks

http://www.brickwerks.co.uk/index.php?p ... t&Itemid=6" onclick="window.open(this.href);return false;

If you assemble the whole caboosh out from under the van it does make sense but it sure doesn't comply with the KISS principle of design. And the tales of puddles of petrol under the van frightens me to death when thinking about cookers and gas fridges! Strangelly enough my small rubber hoses were in good nick but I replaced them nyway
Yes I did buy the proper hose clips but am still four short after clearing Half(baked)fords stock of ten. And I am trying to buy the filler seal from brickwerks but the website went down or timed out (or maybe it was sunspots) and now I can't get back in as the user name I don't remember entering is unknown to me. I Work three days a week on a computer doing all sorts of clever stuff and sill ocasionally get defeated by a website! Or am I getting past it?
Cheers
Wolfie

In fairness I should say that I got a phone call today in response to last nights email. Apparently the Brickwerks registration take your email address as your user name and if it is too long it falls over. They hope to fix this soon, Gave them my card number and the stuff is in the post. Excellent service.
Cheers
Wolfie