Club 80-90 Forums

Hi, I've been doing (on and off) an engine swap from a 2.8 Capri over to a Pug 2.1 which I started about a year ago!!! The engine is in but now I need to do the fuel, plumbing and electrics and and have a couple of questions.

Fuel system - I'm using the in-line fuel pump that was used when the Capri engine was fitted. My question is, does anyone think this will cause problems or should it be ok?
Plumbing - trying to work out the flow of water, which pipe goes to where? Long pipe from radiator to water pump side of engine or other side ?

Any assistance woud be greatly appreciated..

Cheers
Brett

I can't offer any help but presumably you're installing this in a t25?

From reading a bit on http://www.vwkd.co.uk/ about Peugeot conversions a while back, I believe famousphil is the man you need to speak to...

Yes, it's a T25 transplant. Thanks, I will try Phil.