Club 80-90 Forums

right got to replace one of there on the drivers side of the camper 2.1 DJ as the clip that holds it of spaped with a loadd of the pipe that wouuld fill it (on the top), the problem that i have is that the 2 tank return pipes are sitting read to be reconected. but the top (over flow from the petrol tank) ppipe is no where to be seen. i looked in the bently and it is fed from a charcoal filter then to a T peice to a tank eather side on in the wheel arch. dose any one know where this filter is then i can run every thing fresh,

thanks neil

Firstly Bentley manuals are for North American vehicles some of it is not relevant to European models. You would be better off supplementing it with a Haynes Manual as well.
The two breather pipes from the tops of the expansion tanks just clip to the top of the chassis rails with the ends above the tank curving downwards with a couple of rubber bell ends on them.