Club 80-90 Forums

Just a quick one
I have changed the temp sender on the thermostat housing, only lost about 1/2 a pint of coolant.
Bled the system and its all running ok, temp in the middle of the gauge, fan cuts in and out etc all ok.

Checked the top up tank (behind the number plate and thats on max so ok) but it has a few bubbles -- will these be ok or do i need to bleed again?

Thanks
Darren

bubbles where? in the header or the top up

run it for a couple of normal days driving.. then re bleed, any that may have got in will generally have com out, or moved to the bleed points..

sorry the bubbles are in the top up tank

good that's where they should be

kevtherev wrote:good that's where they should be

so kev are bubbles in the top up ok ? or does it mean i still have air in the system?

Many Thanks

Darren

ps how do you know if there is any air in the system ??????

If its coming out into the top up tank it means the cap is working and the air is being released... need to check the rad bleed in a couple of days to make sure nothing has been "transported" to the front.. remember to crack that open only once its up to temp and got some pressure in the system..

Thanks all,
I have run it for a week and there are NO bubbles anymore. All seems well
Darren