Club 80-90 Forums

Hi

I brought a 2nd hand T25 90 Amp Altenator recently to upgrade.

However, it might be me being stupid but it looks slightly different to my current one on my DG engine? Exterior the same but the mount plate looks slightly different.

The code is below

025 903 023E

Could it be I've of brought one for a 2.1 DJ engine?

Nesty

You have bought the std 1.9/2.190amp alt part number, so should go on..

Mount plate???

maybe your old one is wrong?

I have only offered it up and it looked a bit different. Just wanted some opinion before going ahead with the work.

What I meant by mount plate. Slightly wrong choice of word. I meant the bit on the alternator where the upper bolt holes goes through to the adjustable slider plate.

got a pic?

WHS^^^ A pic..
As the wbx alts are all pretty much the same shell..

I have seen a van recently that had a Rover alt put on by a garage as they couldnt find a replacement.. charged a lot for it too.. must have been some "richard head" to not be able to find a VW alternator...

here's mine off a 2.1

Kev the rev that's it. The one I brought is the same as that one inthe pic.

My existing one on at present where the 2 upper boltholes are, seemed to be a slightly different shape then the one I brought. However it should be all ok then?

will be ok , thers a couple of types, but all fit

only other difference is wiring , early stuff used push on connector. later as pictured!

OK cheers. Yeah I have the early push on connector. So gota cut and crimp new connections.

8mm and a 6mm