Club 80-90 Forums

Hi,

am tackling the seams with grinder, wife brushes etc, going to Vactan x2 then was thinking zink rich primer and then flexible sealant before more primer then combi-colour. What to use, is Tiger seal right for this use or the stuff that JK sells (expensive)?
or other?

thanks.

Tim

This is what you need mate
http://www.halfords.com/webapp/wcs/stor ... yId_165625

Thanks, funnily enough i've got this and use it so seal welded seams inside or underneath but was thinking on exterior side seams it would be best to use a tube of sealant in a gun to force it into body seam crevices? T

would be best to use a tube of sealant in a gun to force it into body seam crevices? T

Nah, do your rust prevention bit then a bit of masking tape either side of the seam then brush it in and smooth with your finger, remove tape before it goes off smooth with finger any sealent lip and then ready to paint over once set. job done

Thanks. Makes sense. T

do they do smaller tins ?

rattybird wrote:do they do smaller tins ?

Loads about from motor factors or online, you use alot more than you think!

you can if you wist use tiger seal!

lots of different types , and yes in a gun you can force it into the seam.

lots of tried/tested ways.