Club 80-90 Forums

Does anyone know wher i can get an early sliding door handle gromet spacer. iv got a rubber ring behind it at the min keeping it from moving about. cheers steve

NLA

2nd hand is your only avenue

I take it you have tightened the screw?

yeah done all that. It had a late handle on it that had a pipe welded on for length. Was a propper scrap heap challenge

I sourced one via wanted and I still have a big o-ring on too for a better seal as the old grommet just sits in the hole unlike the bigger later version that actually seals

just fit the seal of the later style handle with a little file ing it fits correctly and takes all the slack out of your handle

Cheers for that i'll try that .

It doesn't fit in the hole in the door as it's too big but it will act as a spacer