Club 80-90 Forums

Hi all,

I have just discovered a water leak. one of the pipes that run from the expansion tank to the front had dropped onto the drive shaft which in turn had worn the pipe down. I have a length of pipe to just replace a small section but am wondering if there are any hints and tips (like how to bleed the system) that I need to be aware of when refilling the system?

Cheers,
H

What engine?

Info about bleeding is in the wiki:
https://club8090.co.uk/wiki/Co ... ing_system" onclick="window.open(this.href);return false;

Tony

ah, good point, it's a JX (1.6TD).

Just looked at the wiki; cheeers, looks simple enough! Am going to stick a blob of Stick Like Sh*t on it, that should hold it until next weekend

Cheers,

H

More info here as well:
http://www.brick-yard.co.uk/forum/bleed ... 29710.html" onclick="window.open(this.href);return false;

Tony

Thanks again Tony , this my first Job Saturday (hopefully complete it before misses gets up) !

Done and was a doddle!