Club 80-90 Forums

evening all, could any one tell me the best tool for cutting the groove round interior doors and table top to fit the t trim into.i have a router and one of those dremmel thingmebobs, i need to know the best bit to put in them to do the job.thanks

Use a bearing guided slot cutter in your router

http://www.axminster.co.uk/category-Slo ... 207689.htm" onclick="window.open(this.href);return false;

Andy

thanks andy

A lot more accurate if you have a router table. (hands,therefore slot, tend to wobble a lot without)

Hi, could i just tag a relevent question onto this thread. What size cutter should be used with these t-trims?

cubensis wrote:Hi, could i just tag a relevent question onto this thread. What size cutter should be used with these t-trims?

hi its a 1.5mm to 1.8mm depending on the trim,

Okat, thanks alot, after a little more research what you write seems spot on, 1.5mm seems to be the standard. Although i had a 1.5mm cutter that got stolen and it was an ultra tight fit. Just so people know!