Club 80-90 Forums

Ok please bare with me, the van failed its MOT today on the back brake pipes that all meet togther into the cylinder (not sure on the term he used sorry)
Now the garage say they will make new ones up using copper to replace them-is this the right way to go or do i post up for some new ones or second hand ones?
I am very green so please be gentle
forgot to say its 1989 1.9 lpg watercooled x

They are exactly right. They are easy to make and its cheapest that way...

Ringo

ringo wrote:They are exactly right. They are easy to make and its cheapest that way...

Ringo

thanks very much Rich xx

Is the correct answer, cheap as chips (fingers crossed)

BaaaadSlider wrote:Ok please bare with me, the van failed its MOT today on the back brake pipes that all meet togther into the cylinder (not sure on the term he used sorry)
Now the garage say they will make new ones up using copper to replace them-is this the right way to go or do i post up for some new ones or second hand ones?
I am very green so please be gentle
forgot to say its 1989 1.9 lpg watercooled x

Should of come knocking to me if you wanted a T25 friendly tester, I'm toomanytoys new tester...when he can get them to me.
Would of still failed it on the brake pipes though
IAN

Slightly unfair Ian... it was the missus that failed to get it there...

And I could have done a pre mot inspection to see if anything might need doing... So, you have bought a new van then?

toomanytoys wrote:Slightly unfair Ian... it was the missus that failed to get it there...

And I could have done a pre mot inspection to see if anything might need doing... So, you have bought a new van then?

Let you off then