Club 80-90 Forums

Hi all looking for some advice iv got a set of 15"steel wheels off mt T4 just wondering how much work would it be to get them to fit on to my 14" syncro as i fancy putting bigger wheels on

any advice would be greatful

ANYONE

think you have to enlarge the hole for the hub try looking on brickyard or even ask in the syncro section

Nathan, the centre boss will require machining to accommodate the larger T25 diameter - 66.5mm I think.
The PCD is the same 5/112.
The ET, wheel offset, is too big - T4 is about 55 as far as I can recall , T25 about 35 so a 20mm adapter is required.
However, I found that if you fit an adapter you may not need to the machine the boss diameter!
Have you read this.....
http://www.brick-yard.co.uk/forum/defin ... c1290.html" onclick="window.open(this.href);return false;

Doug
PS Ian, at Syncro-nutz, had a pile of 15in rims that had been machined to fit the T25 with the correct ET , may be cheaper to buy a set of rims from him.
PPS Alternatively have a look at http://www.kinkymicks.com/products.php?cPath=4" onclick="window.open(this.href);return false; although they may not be listed I'm sure he can get the adapter you need, that is 5/112 to 5/112, thickness is 23mm I think. I've had a couple of sets from him.

Hi Doug thanx for that do you think it ll be to much hassel to both doing or shall i just continue to use the original 14" steels cause im not to sure how easy it is to get some AT tyres for 14" wheels

You'll have more choice with a 15in rim although I think BFG ATs may still be available in 14in - I believe this topic has been raised a few times so it might be worth doing a search of the forum for additional information

Yr iv done a quick search but there does nt seem to be any definate answers for it my aunty owns a tyre fitting form in Brecon so i might give thema ring today and see what they can get in stock thank you for yr relpys ill let you know how i get on

aarrgh! boring out centres of t4 steelies, nah, no thankyou, too risky, just get 15 or 16" mercs and be done with it, no centre boring needed, offset suitable, pcd good, price- cheeeap used