Club 80-90 Forums

Hi, does anyone know if a set of alloys off a t4 will fit my t25? as I have the chance of getting some cheapish, Im just not sure if the bolts are the same diameter. Thanks.

bolts and pcd will be the same

however the offset will be wrong , and depending on the whell(many different ones) they will probably hit the brakes on the front!

also the center bore in the middle hole og the alloy will probably be too small to go over the bearing grease nut/ rear hub nut.

really all depends on the wheel , chances are aftermarket ones will fit , originals wont without spacers/machining

Hi, cheers for that Im going to try one on for size this weekend, and also going to ring Performance Car Shop off ebay and see if they could tell me what bits I would need as I now know what sort of wheels they are. Thanks again.

Everything you need to fit the alloys(apart the machining)is available from Brickwerks.

http://www.brickwerks.co.uk" onclick="window.open(this.href);return false;

Cheers for all the info. Ive have found out that it would cost me a lot to make these wheels fit and therefore Im not going to bother with them and go for some nice Merc Vito alloys instead as I have been told I won't need to do a lot, apart from longer bolts?!, to get them on. Maybe thinking of Vito steelies for the stealth look!!

You will still need longer rear studs and spacers for Vito alloys.

viti wheels are mostly et 50 and will rub the front!

Do you know if you will need spacers and longer bolts etc for Vito 16" steel wheels? as Im thinking of the steel one's and then putting larger diameter tyres on the rear to give it a beefey look and maybe a few more mph.

rears fit , spacers for the front , ideally for the rear to keep the track the same.

et is 57 as opposed to the vw 39

Do you know big you could go with the tyres on the rear?