Page 1 of 1
internal heater unit
Posted: 03 Dec 2009, 16:23
by rubyvan
Hi
Can anyone tell me how to fix in a heater (that runs from the water heated by the engine and goes in the back under the rock and roll bed in a westy).
Is it fairly easy to do ?
Steve
Re: internal heater unit
Posted: 03 Dec 2009, 18:07
by kevtherev
I believe it is possible to retro fit this..
you take a branch off the radiator inflow
but controlling the flow through the matrix is er..difficult.
I don't think VW fixed this..but not sure.
good idea though

Re: internal heater unit
Posted: 03 Dec 2009, 18:11
by SyncroSwede
I have one of these heaters fitted at the factory as an option. There is a fan speed control to the left of the other controls on the dash and the valve on the side of the matrix itself. You obviously cannot adjust the heat by remote but it is an amazing heater in the winter, especially for those at the back and I think worth fitting.
Perhaps you could get the matrix and controls out of a scrapper? That way you can see how it was wired and plumbed in...

Re: internal heater unit
Posted: 03 Dec 2009, 18:19
by pocolow
Ive got one in my van doesnt' work ( fan burn't out) but welcome to come and look at it. Going to rip it out any way.

Mark
Re: internal heater unit
Posted: 03 Dec 2009, 18:24
by kevtherev
SyncroSwede wrote:and the valve on the side of the matrix itself. You obviously cannot adjust the heat by remote
aahh haaa
but it is an amazing heater in the winter,
I bet it is
