Club 80-90 Forums

Does anyone have one of these laying about which they are willing to sell to me for my front diffs?

i'm sure CJ will have one for sale

Cate, if you can wait a week or so (I'm away from home), pmail me your addy and I'll pop one in the post.

Thank you Andy, no huge hurry, you have pm.

Cate,

Additional to the roll-pin and circlip I'm sending...

Have you got the two long thin set screws that hold the actuator on?
The spacing plate that goes under the bracket?
Is this front or back difflock?

Thomas did give me the bag of stuff when I bought the truck so most of the stuff is still there......

You're a star, thank you. This is front difflock Clive, i have the bracket, the two long bolts, 2 short bolts, a washer, the spacer plate, a bent circlip......... the old actuator is still on the truck, (left on so we know which pipe is which and the wont get muck in them)
i think there was something else, its all out in the van so I will have a look and report back... not sure about the 'collar'?

Ok checked, there is also a ?pressure sensor? electric connector goes into it.

Circlips are designed as single use only items. If it's knackered then replace it and stop whining.

Now what! I know they are single use, I am not whining, I am not getting at you, don't take it so personally, I have never ever blamed you for anything thats happened with the truck, I've told you that, even when others have pointed the finger, you know I was mad at you about the front diff, and you know why, thats it, end of......so stop getting at me, neither of us need it.

I'll send the circlip and the roll-pin now then, both new, not that it matters much!
Sometimes the heads on those bolts get rounded off, or the threads corrode, all being so small, but if they're OK, then I'll keep mine as spares. Easy enough to send if you need them.

The heads and threads look fine so they should do another turn, thank you Clive, I owe you.