Club 80-90 Forums

Any suggestions.....

I am struggling to remove the cluth bolts from my JX flywheel.....so tight the cap heads ard rounding!!

any tools to help, or can anyone over me another JX flywheel for my AAZ conversion....atleast until i can get the old clutch off

Does anyone know what type of flywheel i would need, is it a T25 only part

Thanks for any suggestions....

I've got one you can swap Kieran if your desperate - but i dont know how i'll get it to you.

Give me yours back when you get it off!

I've never had a problem getting them off TBH.

Im in Nottingham...

Ringo

thanks ringo...

I'll give it another go Sunday...

I don't mind collecting from Notts if i need it, Im only in Wolves.

Keiron

Irwin Bolt Grips will get them out, available machine mart etc....also excellent on knackered cv bolts and in fact on anything if you have the full set and the add on set covers everything 8mm to 17mm and imperial

I have a full set of them there brill!!! plus ?I've had some real pig of a job ones and they undone them and I was giving them some hammer!

You mean this one?

http://www.machinemart.co.uk/shop/produ ... extractors

Its Christmas coming up and this looks like a good present...

Ringo

no those are tiny one's is these ones mate!

http://www.machinemart.co.uk/shop/produ ... t-grip-set

Thanks James,

I've seen these used and your right - i need a set

Ringo

thanks guys...

think i'll be needing a set too!!

Dear Irwin
please can I have my commission
love
Aidan

I need them too

jed

for the record....

machinemart coundn't help - irwin tools only seem suitable for bolts, not cap heads!!

but an hammer, chiesel and a star bit (used like an alan bit) and hammered in, did remove all bolts..

well done mate
relieved huh?

machinemart coundn't help - irwin tools only seem suitable for bolts, not cap heads!!

"Balls" - use them for this purpose all the time and they work on phillips head screws too

agreed, anything you can smack them on, comes off,,
mike