Page 1 of 1
CUPBOARD LATCH
Posted: 10 Sep 2009, 10:13
by Moony Moon
Probably clutching at straws on this one, but here goes.....
Any one have any ideas on where to get one of these.....or do you have one lieing around in your garage????
Have managed to snap the white plastic bit off of one door, so we now have a swinging door.
Its off of T25 Leisuredrive Hi-Top Crusader that was converted in 1990.
Cheers
Dale
Re: CUPBOARD LATCH
Posted: 10 Sep 2009, 13:47
by Mocki
is it just the plastic bit you have broken?
it screws into the metal.
i may have one here that has the metal bit broken, but the plastic bit is ok....
been looking for spares of these for years.... not many leisuredrive interiors get scrapped it seems....
other catches will work tho...
Re: CUPBOARD LATCH
Posted: 11 Sep 2009, 19:46
by kirrie
I had the draw one break on me (it was the metal bit though) I swapped it with the rear wardrobe door one (the one facing the rear door) just thought it might be a temp solution !
Re: CUPBOARD LATCH
Posted: 14 Sep 2009, 11:23
by Moony Moon
Yep i'm after the plastic screw in bit as its snapped clean off.
I too have swapped it with the back cupboard temporarily......could be like it for a while i fear! I have emailed Leisuredrive but no response, but i guess they were busy sorted themselves our for Vanfest.
Had a good look round Vanfest but didn't see anything that looked like it will do the job unfortunately.
Re: CUPBOARD LATCH
Posted: 14 Sep 2009, 14:24
by Mocki
i have looked everywhere, i cant find the busted one i got at the moment.... however, neil hakuna matata did have some spare ones i was supposed to have, might be worth giving him a shout (pm) see if he still has them.......