Club 80-90 Forums

Hi,
The tinware under my push-rod tubes is held together by rust. Where can you get new bits?

SEE MY LAST POST!

Syncrospares?

Not to hard to make either. Sheet aluminium bends and cuts easy - made loads for bays and beetles that had bits missing. Also seen it made from those thick foil barbeque charcoal containers!

Just buy from the dealers!

IIRC they are ~£50 per side from VW Van Centre

Ian

try spannerboy i got a really good set off him for about 12 quid a side i think, might have been less.

jed

Jed simon doesnt have any at the moment

Just got (literly) today both sides for a d.g 1.9 from vw van centre main dealer £43 a side

Useless buggers. I phoned Exeter Monday they told me they were no longer available. Will try again.
Are yours cheaper/same quality Mr Brickwerks? Couldn't see them on your site.

VW heritage sell them too i think.

jed

By the time you've ordered them it'll be easier to make em

I have a pair on the shelf, if your van centre talk "pooh" drop me a mail and I'll bag them up for you.

Cheers Simon but, as suggested, for £90 I'll have ago.

Quick question..... Is a 1.9 tinware the same as 2.1 come to that is the old Aircooled 1600/1300 type1 engine the same, are bolt holes/dimensions the same? Would pushrod tinware from one fit the other?

afaik it's all different, certainly different part nos.
Surely syncrospares have got a pile of these there were quite a few engines scrapped in the last few years and CJ would have stripped them, new owners may have got to the bottom of the pile.

is the tinware needed on a wbx
mine fell off some time ago and dont seam to have a effect

They are there to protect your thin-walled ali push-rod tubes. Thinking of making some, shall I put you down for first order?

Okay Aidan, are 1.9 & 2.1's the same?