Page 1 of 1
Rear Wheel Bearings: Undo Drive Shaft Bolts
Posted: 13 Jul 2009, 10:26
by PoloSi
I am in the process at the moment of replacing my rear bearings. Before I try I just wondered if anyone new the size of the allen headed bolts that secure the drive shaft on. Didn't want to start trying all different size allen keys and end up rounding it off!
Simon
Re: Rear Wheel Bearings: Undo Drive Shaft Bolts
Posted: 13 Jul 2009, 12:16
by Aidan
6mm allen or M8 12pt sometimes
Re: Rear Wheel Bearings: Undo Drive Shaft Bolts
Posted: 13 Jul 2009, 12:32
by PoloSi
Nice on cheers for the info mate.
Simon
Re: Rear Wheel Bearings: Undo Drive Shaft Bolts
Posted: 13 Jul 2009, 12:50
by jebiga41
off the top f my head i think its i six they can also be an m8 spline clean the area thouroughly and spray wd40 or shock an unlock all over them (avail in halfords) you should ideally replace the bolts dont lose or forget the washers and also regrease the cv joints. a word of caution if you do find replacement bolts make they are 12.9 or 10.9 steel not 8.8 as these do not hold the torque also have look on the wiki or the bently if you've got one
Re: Rear Wheel Bearings: Undo Drive Shaft Bolts
Posted: 13 Jul 2009, 12:52
by jebiga41
you're quick on the draw today aidan
Re: Rear Wheel Bearings: Undo Drive Shaft Bolts
Posted: 13 Jul 2009, 16:11
by PoloSi
Does anyone know where I can buy the new bolts to replace my old 6mm allen head ones?
Gsf?
Brickwerks?
Vw?
Simon
Re: Rear Wheel Bearings: Undo Drive Shaft Bolts
Posted: 13 Jul 2009, 16:27
by axeman
when i replaced the cv boots (inner and outer) at the same time the new boots that i bought from EURO car parts, (competetor to GSF) the new boots came with the new bolts and the funny washers that joint 2 bolts together, daose that make sence about the washers? and the grease.
hope this helps neil
Re: Rear Wheel Bearings: Undo Drive Shaft Bolts
Posted: 13 Jul 2009, 23:43
by PoloSi
Does anyone knwo if I would be able to aquire these bolts from vw?
Simon
Re: Rear Wheel Bearings: Undo Drive Shaft Bolts
Posted: 14 Jul 2009, 02:05
by lhd
I'm sure you can still get them as they are widely used on most Vw's. If not GSF do an alan key type a tad shorter and you will need some thread lock so probably best to get originals if poss as they have thread lock on them, thread lock is expensive for how much you get.
Rob.